ERD 02K: Rigidez Dieléctrica 2500V
Dielectric Strength 2500 Vac.
Equipment designed for the Dielectric Strength Test on cables.
It has a variable output voltage between 1000Vac to 2500Vac.
Main Specifications
- done Test Voltage up to: 2500Vca.
- done Fail current: 5mAca.
- done To test wires / cables.
Equipment designed for the Dielectric Strength Test on cables.
It has a variable output voltage between 1000Vac to 2500Vac.
To perform the test of Table 3, the IRAM NM 247-1.
This test was performed on the wire immersed in water with a temperature of 20 °C.
The sample must be subjected to these conditions for 1 hour.
Then apply the test voltage for 5 minutes.
TECHNICAL SPECIFICATIONS
Power Supply
220Vca, 50 Hz, Single-phase
Output Voltage
up to 2500 Vca.
Indicators
done Display LCD 2 líneas.
done LEDs of OK o FAULT.
done Audible.
done LEDs of OK o FAULT.
done Audible.
Specifications
To use over table.
Totally controlled by microcontroller.
Pliers Test.
Totally controlled by microcontroller.
Pliers Test.
Output
2 Test Clamps.
Dimensions
400 x 350 x 225 (h) mm.
Weight: 25 Kg.
Weight: 25 Kg.
Guarantee
12 months.
According to
IRAM NM 247-1.
IEC 60227-1.
IEC 60227-1.
