DTF 01: Torque Tester Apparatus
DTF 01: Torque Tester Apparatus
The TORQUE TESTER APPARATUS from SECOM - designed according to IEC 60065 - is a test to check cuplé done by various elements that are connected to sockets.
DTF 01: Torque Tester Apparatus (IEC 60065 - Figure 11)
The TORQUE TESTER APPARATUS from SECOM - designed according to IEC 60065 - is a test to check cuplé done by various elements that are connected to sockets.
A device provided with pins intended to be introduced into fixed socket-outlets shall not
impose undue strain on these socket-outlets.
Compliance is checked by engaging the device, as during intended use, with the socket-outlet of a test apparatus as shown in figure 11. The balancing arm of the test apparatus pivots about a horizontal axis through the centre lines of the contact tubes of the socket-outlet at a distance of 8 mm behind the engagement face of the socket-outlet.
With the device not in engagement, the balancing arm is in equilibrium, the engagement face of the socket-outlet being in the vertical position.
After the device has been engaged, the torque to be applied to the socket-outlet to maintain its engagement face in the vertical plane is determined by the position of a weight on the
balancing arm.
The torque shall not exceed 0,25 Nm.
TECHNICAL SPECIFICATIONS
Weight: 8 Kg.
0,500 Kg.
done IEC 60065